
Elk Grove Repiping: Partial Repipe in Elk Grove, CA
Elk Grove Repiping does partial repipes in Elk Grove, CA. If one bathroom, the kitchen, or one side of the house keeps leaking but the rest of the pipe is in good shape, we can replace just that section. You get new lines where you need them without paying to redo the whole house.
Monday to Saturday, 7:00 AM to 7:00 PM
Get a Free Repipe Quote
What is a partial repipe?
A partial repipe replaces some of the water lines in a home, not all of them. It might be the lines feeding one bathroom, the kitchen and laundry, a slab line that keeps leaking, or the hot side only. We tie the new pipe into the existing system and pressure test the whole thing.
When does a partial repipe make sense?
- One area has had repeat leaks and the rest of the house hasn't.
- You're remodeling a bathroom or kitchen and the walls are already open.
- A line under the slab failed and rerouting just that line through the attic is the cleanest fix.
- An addition or older section of the house has different pipe than the rest.
- The hot lines are failing faster than the cold lines.
When is a whole house repipe the better call?
Sometimes a partial repipe is just a delay. If the house has polybutylene or Kitec, the pipe and fittings are the same age everywhere. Fixing one bathroom leaves the same risk in every other wall. The same goes for copper that's pinholing in more than one place.
We'll look at the pipe, test it, and tell you honestly which way makes sense. If a partial repipe will do the job, we'll price it that way. If you're likely to call us again in a year, we'll say that too. Compare it with a whole house repipe.
How does a partial repipe work?
- We find where the problem section starts and ends.
- We plan a route for the new lines, usually through the attic.
- We shut off the water, cut in new tie-in points, and run the new pipe.
- We cap off or remove the old section.
- We pressure test the old and new pipe together.
- After the inspection, we patch the drywall.
Most partial repipes take a day or less. Bigger ones, like half the house, can take two.
What pipe do you use?
Usually PEX. It ties into copper, CPVC, and most other existing pipe with the right transition fittings. If your house is already copper and you want to keep it that way, we can use copper for the new section. See PEX repiping.
Do you patch the drywall after a partial repipe?
Yes. Every opening we make gets patched, textured, and left ready for paint after the inspection.
Related services
Areas we serve
Partial repipe FAQs
How much does a partial repipe cost?
Less than a full repipe, but it depends on how much pipe and how many fixtures. See our cost guide or call for a price.
Do I need a permit for a partial repipe?
In most cases, yes. We'll file it with the city or county and schedule the inspection.
Can you connect PEX to my old copper?
Yes. We use approved transition fittings that join PEX and copper the right way.
Should I repipe during my bathroom remodel?
It's a smart time to do it. The walls are already open, so you save on access and patching.
Can a partial repipe fix a slab leak?
Often, yes. Rerouting the leaking line overhead is a common fix. See slab leak repair.
How do I know if the rest of my pipe is okay?
We check the pipe we can see, test pressure, and look at the leak history. That tells us a lot about the rest of the system.