Skip to main content
Gray polybutylene water lines with crimp fittings coming out of a garage wall above an older water heater.

Elk Grove Repiping: Polybutylene Pipe Replacement in Elk Grove, CA

Elk Grove Repiping does polybutylene pipe replacement in Elk Grove, CA. A lot of homes built here in the 1980s and early 1990s went up with gray plastic polybutylene water lines. That pipe breaks down with age and can split without warning. We take it all out and run new PEX or copper to every fixture.

Monday to Saturday, 7:00 AM to 7:00 PM

Get a Free Repipe Quote

By submitting, you agree to our Privacy Policy and Terms of Service.

What is polybutylene pipe?

Polybutylene, or poly for short, is a plastic water pipe that builders used across the country because it was cheap and fast to put in. It's usually gray, though you'll sometimes see blue or black on the line coming in from the street. It's often joined with copper or aluminum crimp rings, or with plastic fittings on older systems.

A national class action settlement over polybutylene plumbing covered systems installed from 1978 to 1995.

Source: Contractor Magazine, polybutylene settlement coverage

Those are the same years a big share of Elk Grove was being built. The county was adding subdivisions here through the 1980s and 1990s, long before Elk Grove became a city in 2000, so a lot of local homes fall inside that window.

Why does polybutylene fail?

Disinfectants in tap water, mainly chlorine, react with the plastic over time. The pipe gets brittle and flaky from the inside. It also doesn't like stress, so bends, tight fittings, and spots where the pipe was pinched during the install tend to crack first.

The scary part is that it often looks fine on the outside right up until it splits. A poly line can go from normal to spraying water inside a wall with no warning.

How do you know if you have polybutylene?

  • Look at the pipe coming out of the wall at your water heater or under sinks. Gray plastic pipe is the big clue.
  • Check the printing on the pipe. Poly is often stamped "PB2110."
  • Look at the fittings. Copper or aluminum crimp rings on gray pipe point to poly.
  • Check your build year. If the house was built from the late 1970s to the mid 1990s, it's worth a look.

Gray pipe isn't always polybutylene. Some newer PEX is gray too. If you're not sure, we can tell you in a few minutes on a walk-through.

Why replace it before it leaks?

Because when poly fails, it usually fails big. A cracked line inside a wall or ceiling can do a lot of damage before anyone notices. Replacing the pipe on your schedule is a lot cheaper than drying out a house after a burst.

Poly can also come up when you sell. Home inspectors know what it looks like and often flag it. Some buyers ask for a credit or for the pipe to be replaced before closing. Some insurance companies ask about it too.

What does a polybutylene replacement involve?

It's a whole house repipe. We replace every poly supply line in the house with new PEX or copper and put new shutoffs at each fixture. Most of the new pipe goes through the attic, with small openings where lines drop down. If the main line from the meter is also poly, we usually replace it in the same job. See water line replacement.

For the details on materials, see PEX repiping or copper repiping.

Do you patch the drywall after poly replacement?

Yes. After the city inspector signs off, we patch every opening, match the texture, and leave it ready for paint. It's part of the price.

Related services

Areas we serve

Polybutylene pipe FAQs

Can I just replace the fittings?

Swapping fittings helps for a while, but the pipe itself is breaking down. Most of the time, it's money spent on a system that will still need replacing.

Is there still a settlement for polybutylene?

The national settlement program has closed, so most homeowners now pay for the replacement themselves.

Will my insurance cover a polybutylene leak?

It depends on your policy. Some cover sudden water damage but not the pipe replacement. Ask your agent.

How long does a poly repipe take?

Most Elk Grove homes are done in one to three days, plus the drywall patching after the inspection.

Is all gray pipe polybutylene?

No. Some PEX is gray. The printing on the pipe and the fittings tell the story. We can check it for you.

My poly hasn't leaked yet. Do I still need to replace it?

You don't have to, but the risk goes up every year. Many homeowners replace it before selling or after the first leak.

Have gray pipe in your walls?

Call or send a few details. We'll confirm what you have and give you a price to replace it.

Get a Free Repipe Quote

By submitting, you agree to our Privacy Policy and Terms of Service.