
Elk Grove Repiping: PEX Repiping in Elk Grove, CA
Elk Grove Repiping does PEX repiping in Elk Grove, CA. We pull out failing polybutylene, Kitec, copper, or galvanized water lines and run new PEX to every fixture in the house. Each fixture gets a new shutoff valve, the system gets pressure tested, and we patch the drywall when it's done.
Monday to Saturday, 7:00 AM to 7:00 PM
Get a Free Repipe Quote
What is PEX?
PEX stands for cross-linked polyethylene. It's a plastic tubing built for hot and cold water lines. It's flexible enough to bend around framing and comes in long rolls, so most runs go from one end to the other without a single joint in the wall.
You'll see red PEX on hot lines and blue on cold, and sometimes white for either. The color is just for sorting. The pipe inside is the same.
California added PEX to the state plumbing code in 2009. After a legal challenge, the state approved it again, effective August 18, 2010.
Is PEX the same thing as Kitec?
No, and it's a fair question. Kitec is a PEX-aluminum-PEX pipe sold from 1995 to 2007. The trouble with Kitec was mostly its brass fittings, which corrode from the inside. The PEX we install today is solid cross-linked tubing with modern fittings. If you have Kitec now, replacing it with PEX is one of the most common jobs we do. See Kitec pipe replacement.
PEX-A or PEX-B?
Both are approved and both work well. The main difference is how they're made and how they connect.
| PEX-A | PEX-B | |
|---|---|---|
| How it's made | Engel method, cross-linked during forming | Silane method, cross-linked after forming |
| Flexibility | Very flexible, tight bends | Stiffer, wider bends |
| Fittings | Expansion fittings that keep the inside full size | Crimp or clamp rings over an insert fitting |
| Kinks | Can be fixed with a heat gun | Usually needs a coupling |
| Cost | A little higher | A little lower |
On most Elk Grove homes, we lean toward PEX-A because of the bends in a tight attic and the full-size fittings. If budget is the main concern, PEX-B is a good pipe too.
Why do homeowners pick PEX for a repipe?
- It costs less to install than copper because there are fewer fittings and less labor.
- It bends around corners, so we can make smaller wall openings.
- It won't pinhole the way copper can.
- It holds up to freezing better than rigid pipe, though no pipe likes to freeze.
- It's quiet. You get less of the banging some copper systems make.
It's not perfect for every spot. PEX can't sit in direct sunlight, so we keep it out of exposed outdoor runs. And it needs to be supported properly in the attic so it doesn't sag. Those are install details we handle on every job.
Home run manifold or trunk and branch?
There are two common ways to lay out PEX.
A home run system uses a manifold, usually near the water heater or in the garage. Each fixture gets its own line straight from the manifold, with its own shutoff. If a toilet supply needs work, you shut off that one line and the rest of the house keeps water.
A trunk and branch system runs a larger main line through the house, with smaller lines teeing off to each fixture. It uses less pipe and works well in smaller homes.
We'll recommend one based on your floor plan and fixture count. Many two-story Elk Grove homes do well with a manifold.
What does a PEX repipe look like in Elk Grove?
Most homes here were built on slabs, with the water lines either under the concrete or in the attic. When we repipe, we almost always go overhead. The new lines run across the attic and drop down inside the walls to each fixture. That way none of the new pipe is under your floor.
On a two-story house, we run lines through the attic for the upstairs and use interior walls and soffits to reach the downstairs. We plan the route before the first cut so the openings stay small and in places that are easy to patch.
Do you patch the drywall after a PEX repipe?
Yes. Once the city inspector signs off, we patch each opening, match the wall texture, and leave it ready for paint. Patching is part of our price, not an add-on.
Related services
Areas we serve
PEX repiping FAQs
How long does PEX last?
PEX has been used in North America for decades. Installed to the maker's specs and kept out of sunlight, it holds up well for a long time. Ask us which brand we're using.
Does PEX affect the taste of my water?
Some people notice a slight taste with brand-new PEX for a short time. It usually goes away after the lines are flushed and used.
Can rodents chew through PEX?
They can chew most plastic, and PEX is no exception. In an attic with a rodent problem, we can sleeve exposed runs. Fixing the entry points is the real fix.
Can you put PEX outside?
Not where it gets direct sun. Outdoor sections and hose bibs get copper or another sun-rated material at the wall.
Is PEX approved in Elk Grove?
Yes. PEX is allowed under the California Plumbing Code, and the City of Elk Grove inspects PEX repipes like any other plumbing permit.
How much does a PEX repipe cost?
It depends on fixtures, stories, and access. See our Elk Grove repipe cost guide, or call for a price on your house.